Vertical Axis Gear Reducer with Soft Tooth Surface

vertical axis soft tooth surfce equipment reducer:
Broadly used in metallurgy, mining, lifting, transportation, cement, development, chemical sector, textile, printing and dyeing, pharmaceutical and other fields.
Scope of software:

one. The high pace shaft pace shall not exceed 1500 rpm

2. The round pace of gear transmission shall not be higher than 20 meters per second

3. The doing work setting temperature is: – 40-forty five degrees. If it is reduced than degrees, the lubricating oil should be preheated to earlier mentioned levels before starting. The reducer can be utilized for each optimistic and damaging operation.

attribute:

1. The gear is made of large-power reduced-carbon alloy steel following quenching, and the hardness of tooth surface reaches HRC58-sixty two. The gear is floor with high precision and excellent get in touch with variety,

two. Higher transmission performance, solitary phase a lot more than ninety six.5%, bipolar increased than 93%, a few levels far more than ninety%

3. Steady procedure and lower sound

four. Modest volume, gentle weight, prolonged services daily life and substantial bearing ability
 

  1. Easy to disassemble and check, easy to set up

Equipment reducer is to use all amounts of equipment transmission to obtain the objective of deceleration. Equipment reducer is composed of all ranges of equipment pairs. For instance, with small gears to generate massive gears can obtain a specific objective of deceleration, and then the use of multi-level construction, you can significantly minimize the velocity.
Equipment reducer
Gear reducer is an exterior meshing involute helical cylindrical equipment reducer manufactured according to the national expert common ZBJ19004. Equipment reducer is a rotating mechanism extensively employed in CZPT China for tower crane machinery. It is broadly utilised in metallurgy, mining, lifting, transportation, cement, development, chemical industry, textile, printing and so on. Dyeing, pharmaceutical and other fields.
Scope of application
one, large velocity axle rotation is not increased than 1500 rpm.
two, the circumferential speed of gear transmission is not greater than 20 m / sec.
three, the operating setting temperature is -forty-forty five C, if the temperature is beneath C, the lubricating oil need to be preheated to far more than C prior to beginning.
four, gear reducer can be used in two instructions.
CZPT features
1. The gear is made of higher-power low-carbon alloy metal by carburizing and quenching. The hardness of the tooth surface area reaches HRC58-62. The equipment is grinded by NC grinding technology. The precision is large and the contact is good.

2. transmission rate is high: one phase is greater than 96.5%, two-phase is greater than ninety three%, and three stage is increased than 90%.
3. sleek operation and low sounds.
4. modest dimensions, light-weight weight, prolonged services lifestyle and large carrying ability.
five. effortless to eliminate and straightforward to install.

Vertical Axis Gear Reducer with Soft Tooth Surface