vertical axis delicate tooth surfce equipment reducer:
Widely used in metallurgy, mining, lifting, transportation, cement, design, chemical industry, textile, printing and dyeing, pharmaceutical and other fields.
Scope of software:
one. The large velocity shaft pace shall not exceed 1500 rpm
2. The round speed of equipment transmission shall not be greater than 20 meters per second
three. The operating setting temperature is: – 40-forty five degrees. If it is lower than degrees, the lubricating oil need to be preheated to previously mentioned levels just before starting up. The reducer can be employed for equally optimistic and unfavorable operation.
attribute:
one. The gear is made of substantial-energy low-carbon alloy steel soon after quenching, and the hardness of tooth area reaches HRC58-62. The equipment is ground with substantial precision and excellent contact kind,
two. High transmission efficiency, solitary stage a lot more than ninety six.five%, bipolar better than 93%, 3 levels much more than 90%
three. Steady procedure and reduced sounds
four. Small volume, mild excess weight, lengthy provider existence and higher bearing ability
- Simple to disassemble and check out, effortless to install
Gear reducer is to use all ranges of equipment transmission to achieve the objective of deceleration. Gear reducer is composed of all stages of gear pairs. For case in point, with little gears to push large gears can attain a specific goal of deceleration, and then the use of multi-amount composition, you can greatly minimize the velocity.
Equipment reducer
Equipment reducer is an exterior meshing involute helical cylindrical gear reducer manufactured according to the national expert normal ZBJ19004. Gear reducer is a rotating system widely utilised in CZPT China for tower crane equipment. It is broadly used in metallurgy, mining, lifting, transportation, cement, construction, chemical sector, textile, printing and so on. Dyeing, pharmaceutical and other fields.
Scope of application
1, large speed axle rotation is not higher than 1500 rpm.
two, the circumferential speed of equipment transmission is not better than 20 m / sec.
3, the doing work surroundings temperature is -forty-45 C, if the temperature is beneath C, the lubricating oil need to be preheated to much more than C prior to commencing.
4, gear reducer can be utilized in two instructions.
CZPT attributes
one. The gear is produced of substantial-energy lower-carbon alloy steel by carburizing and quenching. The hardness of the tooth surface area reaches HRC58-62. The gear is grinded by NC grinding technologies. The precision is large and the make contact with is very good.
2. transmission fee is high: one stage is increased than 96.5%, two-phase is increased than 93%, and three stage is greater than ninety%.
three. smooth procedure and reduced sound.
four. small dimension, gentle weight, lengthy provider lifestyle and large carrying capacity.
five. simple to eliminate and effortless to put in.
