Involute helical cylindrical equipment reducer:
Commonly used in metallurgy, mining, lifting, transportation, cement, design, chemical sector, textile, printing and dyeing, pharmaceutical and other fields.
Scope of application:
one. The substantial speed shaft speed shall not exceed 1500 rpm
two. The circular speed of gear transmission shall not be greater than 20 meters for each next
three. The working environment temperature is: – forty-forty five degrees. If it is reduce than levels, the lubricating oil should be preheated to earlier mentioned degrees ahead of starting up. The reducer can be utilised for each good and negative procedure.
1. The equipment is made of substantial-energy lower-carbon alloy metal following quenching, and the hardness of tooth surface area reaches HRC58-62. The equipment is ground with substantial precision and great get in touch with type,
2. High transmission efficiency, single phase far more than ninety six.five%, bipolar higher than 93%, three stages a lot more than ninety%
three. Secure procedure and minimal noise
4. Tiny volume, mild excess weight, lengthy service lifestyle and higher bearing capability
- Simple to disassemble and verify, easy to set up
Equipment reducer is to use all amounts of gear transmission to achieve the objective of deceleration. Equipment reducer is composed of all amounts of equipment pairs. For illustration, with modest gears to push huge gears can achieve a specified purpose of deceleration, and then the use of multi-degree framework, you can greatly lessen the pace.
Gear reducer is an exterior meshing involute helical cylindrical equipment reducer manufactured according to the countrywide specialist regular ZBJ19004. Gear reducer is a rotating system extensively utilised in CZPT China for tower crane equipment. It is broadly used in metallurgy, mining, lifting, transportation, cement, development, chemical market, textile, printing and so on. Dyeing, pharmaceutical and other fields.
Scope of application
1, higher speed axle rotation is not higher than 1500 rpm.
two, the circumferential velocity of equipment transmission is not increased than twenty m / sec.
three, the working environment temperature is -forty-45 C, if the temperature is underneath C, the lubricating oil must be preheated to a lot more than C just before commencing.
4, gear reducer can be utilized in two instructions.
1. The gear is created of substantial-toughness reduced-carbon alloy steel by carburizing and quenching. The hardness of the tooth area reaches HRC58-sixty two. The equipment is grinded by NC grinding technologies. The precision is substantial and the speak to is great.
2. transmission rate is high: single stage is higher than ninety six.5%, two-stage is higher than 93%, and 3 degree is better than 90%.
three. sleek procedure and minimal sounds.
four. modest size, gentle fat, long service existence and high carrying capability.
five. easy to take away and simple to set up.